Instructions

Product pretreatment    

Weigh the required Seplife®DX 50/100 and place it in 50~100 times distilled water for swelling. It usually takes 1~2 days to swell at room temperature, and 2 hours in boiling water to allow the media to fully swell until the volume no longer changes.

Note: Add distilled water before swelling to make it settle naturally. After natural settlement, if there are many fragments floating in the solution, they need to be removed by repeated rinsing to prevent blocking the column during chromatography and reducing the flow rate.

Column packing

Column packing should be performed according to standard operating procedures. It is important to ensure that each material is at its working temperature, and the media may need to be degassed before column packing.

Equilibration

Equilibrate the column with an appropriate 2-5 column volume buffer. Ensure the conductivity and pH of the effluent are exactly the same as the buffer.

Sample feeding

1. The separation of sample components by the media is carried out according to the molecular size of the components, and the ones with the larger molecular size flow through first.

2. The sample feeding for gel filtration is generally 5% of the column bed in volume, and we recommend that the initial sample feeding be controlled at 1-2% of the bed volume, which can be adjusted depending on the separation situation. When desalting, the sample feeding can reach 20% of the column bed volume. The selection of column height is also related to the separation requirements. The column height should be controlled below 40cm. Too high a gel layer will cause greater back pressure and should be avoided as much as possible.

Difficult-to-separate molecules must have a certain column height and flow rate control. A 5:1 height-to-diameter ratio for desalting is recommended.

3. Samples with particulates and precipitate should be filtered or centrifuged before the chromatography purification. The viscosity of the sample should not be too high, otherwise the separation effect will be reduced.

Elution

Elution can be done with salt-free water or with equilibration buffer as eluent. Complete separation can be achieved by adding NaCl to the equilibration buffer for gradient elution, or salt gradient elution.

Cleaning-In-Place (CIP)

After the media is used 10 times, a CIP is performed to remove the precipitated and stubborn residual proteins in the column bed. The method is to backwash with 4 bed volumes of 1M NaOH at 40cm/h, and then regenerate with at least 3 bed volumes of equilibration buffer.

Storage

Seplife®DX 50/100 dry powder should be stored in a dry, ventilated and clean place at 4-30℃; the hydrated media should be stored in 20% ethanol solution. Avoid contact with oxidants and do not freeze.

Ordering information

Production date: See label

Expiry Date: 5 years, under proper storage conditions

Manufacturer: Sunresin New Materials Co. Ltd.

Add:No. 135, Jinye Rd, Xi'an Hi-tech Industrial Development Zone, Shaanxi, 710076, China

www.seplite.com    www.sunresin.com

E-mail: info.lifescience@sunresin.com